Ideal for your DIY Halo headlight project (Where 4 outputs are needed) This system can control 4x halos OR 4x chasing strips only. Included: 12v/5v Power Supply 4 Way Driver Board SP105e Bluetooth Controller This wiring kit needs to be installed out of the weather, they are NOT waterproof/resistant. Dielectric grease MUST be used in […]

5VDC 18 Music Responsive Modes 180 Regular chasing modes Brightness control Speed Control Compatible with Switchback drivers. Bluetooth enabled Android/iOS (LEDChord) Compatible with many SRGBWA Applications Suitable for strip/halo control (SRGBWA)

This kit is ideal for retrofitters who are wanting to install demon eyes into their headlights Included: 2x Demon eyes units 1x 5 Pin JST Extension cable Demon eye controller required for operation and NOT included in this kit. These demon eyes run a SK6812 LED Chipset which can be controlled perfectly with the SP […]

This kit is ideal for retrofitters who are wanting to install demon eyes into their headlights Included: 1x RGBW Demon Eye Driver Box. As our Demon Eyes run a SK6812 LED Chipset we can control these perfectly with the Driver module in this kit. This gives smartphone control to change colours and modes. The colour […]

Used to extend the connection of Halos/RGBW Strips and/or demon eyes. 2m in length Available in 3 or 5 Pin models. Contents: 1x 2m JST Extension 12 Month Warranty

Dielectric Silicone Grease. Ideally used for creating a water resistant seal in electrical connectors. Recommended use with 3/5 pin JST connectors used in our Halo/Demon eye headlight builds.

INSTALLATION INSTRUCTIONS: Universal 3PIN RGBW Controller Installation Insructions   This kit is ideal for retrofitters who are wanting to install halo/demon eyes into their headlights. Included: 1x RGBW Switchback Controller. As our Halos/demon eyes run a SK6812 LED Chipset we can control these perfectly with the Driver module in this kit. This gives smartphone control […]

Ideal for Indicator or brake circuits of canbus vehicles. Used to increase load on a circuit to prevent dash errors on canbus vehicles or indicator circuits on vehicles with LED Tail Lights Aluminum housing for optimal heat dissipation. Heat resistant wiring sheath Internally potted for waterproofing. Splice crimps for easy installation.

A H4 Relay Harness is used for the installation of retrofitted projector headlights. This Harness converts the factory H4 plug from the vehicle to allow for low beam & high beam control of the projector when installing projectors into your headlights. Included: 1x H4 Relay Harness Kit

5VDC Bluetooth enabled Android/iOS Compatible with many SRGBWA Applications Suitable for strip/halo control (SRGBWA)